Perle-systems 833IS Manual do Utilizador descarregar pdf (Página 118)

Configuring IP Protocol

102 Perle 833IS User Guide

A DHCP (Dynamic Host Configuration Protocol) server that supports BOOTP may

also be used. Many DHCP servers support BOOTP for the permanent assignment of

addresses for servers on the network.

Use RARP

When checked, the 833IS will attempt to acquire the Server IP address from a

RARP server.

Specify an IP Address

When checked, the 833IS will use the IP address defined in the IP address and

subnet mask fields.

IP Address

Enter a valid IP address in this field. See your IP Network Administrator for this

information.

IP Subnet Mask

An IP network can be partitioned into subnetworks, or subnets. IP networks on a

single LAN segment are not likely to have subnets defined. However, larger IP

network with IP routers are likely to have subnets defined.

If your IP network has not been partitioned, the IP subnet mask will default to the

correct value. If you have set up subnets in your IP network, set the mask as defined

by the IP Network Administrator.

Use Default IP Gateway

When checked, lets the 833IS access external IP networks via a Default IP Router.

Routers can be used to separate your IP network from external IP networks. It is

common to have one router that provides a controlled link to these outside networks

(such as the Internet). This router is known as the Default IP router. It also may be

referred to as the Default router or Default gateway.

If you have enabled Use Default IP Gateway, enter the IP address of the router in this

field. See your IP Network Administrator for this information.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 339 340

Sem comentários

Perle-systems 833IS Manual do Utilizador Página 118